 |
| |
How is the water heated?
The heat dissipated by the motor heats the water up to 40° C. The desired temperature is controlled by the electronic thermostat. The motor is cooled and a separate heater is not required. Heat loss is kept to a minimum thanks to the excellent insulation of the tub. That results in low electric power consumption.
|
What is the Softub spa made of?
It consists of 25 (5mm thick) sheets of polypropylene foam which are hot-welded together. The outer covering is WeatherTex – a plastic foil used in boatbuilding.
|
How much does it cost to operate?
Softubs are very easy on the pocketbook. With the water at a constant temperature of 40° C and 2 bathing sessions a day, the electric power costs per model and day are as follows: Sportster €0.22; Legend €0.40; Resort €0.60.
|
How is water run into and drained out of the spa?
The spa is filled with a hosepipe. If a hot water connection is available, you can enjoy the hot tub immediately. The water is drained by a simple immersion pump. Or if the surface under the spa is suitable, simply disconnect the motor and spa to drain the water.
|
How long does the water remain in the Softub spa?
With the right maintenance, you only need to change the water every 2-3 months.
|
How do I treat the water?
Very little maintenance is required thanks to the ozone system. A pH value of 7.2 – 7.6 is required to maintain excellent water quality. To keep the water sanitary we recommend adding chlorine or active oxygen (once or twice a week). Both products are included in the starter set. Every time you change the water, simply rinse out the cartridge filter inside the spa briefly.
|
How long is the guarantee?
With proper use, a full 12 months guarantee is given on the spa and motor. Do you have further questions? Then simply contact us!
Mail us your questions and requests.
|
| |